Milwaukee 49-59-2006 Hss Annular Cutter 2-1/16 in Sheet Metal

Product Description

The MILWAUKEE 49-59-2006 is a high speed steel (HSS) annular cutter designed for fast, clean hole-cutting in sheet metal and mild steel plate. Its thin-wall construction removes less material than a standard twist drill or hole saw of the same diameter, reducing cutting resistance and heat buildup. The advanced tooth geometry simultaneously cuts, clears chips, and finishes the bore wall in a single pass, producing burr-free holes without secondary deburring. The 3/4 inch Weldon shank is compatible with most small and large magnetic drill presses when used with the appropriate arbor. Licensed HVAC fabricators, ironworkers, pipefitters, and sheet metal mechanics regularly specify annular cutters for structural and ductwork penetrations where hole quality and speed matter.

This cutter is sized at 2-1/16 inches in diameter and is intended for use in mild steel applications, from thin-gauge sheet metal up to thicker plate stock. It fits magnetic drill press setups equipped with a 3/4 inch Weldon arbor. For pilots requiring a center pin, MILWAUKEE specifies use with pin 49-59-0011. The cutter is sold individually, making it a practical direct replacement or addition to an existing annular cutter set.

Key Features

• Advanced tooth geometry cuts, cleans, and clears material in a single drilling pass
• Thin-wall design displaces less material than competing cutters of equal diameter, increasing hole speed
• Produces burr-free holes, reducing or eliminating secondary finishing work
• 3/4 inch Weldon shank fits most small and large magnetic drill presses
• Compatible with center pin 49-59-0011 for guided drilling
• Rated for mild steel sheet metal and plate applications

Compatibility

Designed for use with magnetic drill presses equipped with a 3/4 inch Weldon shank arbor. Use with center pilot pin MILWAUKEE 49-59-0011. Intended for mild steel applications.

Installation Notes

Annular cutters are installed by licensed sheet metal mechanics, ironworkers, and general tradespeople using magnetic drill presses or drill press stands. Before mounting the cutter, ensure the drill press is powered down and the magnet is disengaged. Secure the Weldon shank fully in the arbor collet and tighten the set screw before use. Always insert the center pilot pin before beginning a cut to prevent the cutter from walking on the work surface.

Technical Specifications

• Cutting Diameter: 2-1/16 inches
• Cutter Length: 2.35 inches
• Shank Size: 3/4 inch Weldon
• Material: High Speed Steel (HSS)
• Application: Mild steel, sheet metal
• Weight: 0.6 pounds
• UOM: Each
• UPC: 0045242516100

Standard Information

• Brand: MILWAUKEE
• Manufacturer Part Number: 49-59-2006