Milwaukee 49-16-2553 Impact Wrench Tool Boot

Product Description

The MILWAUKEE 49-16-2553 is a molded rubber tool boot designed to protect impact wrenches from job-site wear. The boot fits as a sleeve over the wrench housing, guarding against scratches, dings, and incidental impacts during use and handling. Licensed contractors, mechanics, and service technicians working in tight or abrasive environments rely on this type of protective cover to extend tool life and maintain grip. It is a passive accessory that requires no fasteners or adhesives to install.

This tool boot is suited for use on job sites where impact wrenches are exposed to concrete, metal framing, vehicle undercarriages, or other hard surfaces. It is a direct-fit rubber sleeve intended for compatible MILWAUKEE impact wrench models. The boot stays in place during operation and does not interfere with trigger access or exhaust ports on properly fitted tools.

Key Features

• Molded rubber construction absorbs incidental impacts and resists surface abrasion
• Sleeve design requires no fasteners, adhesives, or tools to install or remove
• Protects wrench housing from scratches and cosmetic damage during daily use
• Maintains grip surface and tool identification in high-wear environments

Compatibility

Compatible with MILWAUKEE impact wrench models 423K51 and 488D97 as indicated in the product title. Verify fit against your specific tool model before ordering.

Installation Notes

Tool boots are installed and removed by hand without any special tools. Power down and disconnect the tool from any power source or air supply before fitting or removing the boot. Ensure the boot is fully seated around the housing before returning the tool to service. Inspect the boot periodically for tears or deformation that could reduce protection.

Technical Specifications

• Material: Molded Rubber
• Application: Impact Wrench Protective Cover

Standard Information

• Brand: MILWAUKEE
• Manufacturer Part Number: 49-16-2553