Milwaukee 2202-20 Voltage Detector Led 50-1000V Ac Cat Iv

Product Description

The Milwaukee Electric Tool 2202-20 is a non-contact voltage detector with a built-in LED work light, designed for use by licensed electricians and qualified technicians across residential, commercial, and industrial job sites. It detects AC voltage in the range of 50 to 1000 volts and carries a CAT IV 1000V safety rating, which is the highest category rating for electrical measurement equipment. The green power-on indicator light confirms the unit is active and functioning before testing begins. The durable probe tip is built for repeated contact with power outlets and terminal blocks without wear.

This voltage detector is suited for a wide range of electrical service work, including panel inspections, outlet verification, circuit tracing, and general live-wire identification. The integrated LED work light makes it functional in low-light conditions such as crawl spaces, attics, and electrical rooms, effectively combining two tools into one compact unit. It is appropriate for both rough-in and finish electrical work in residential and light commercial settings, as well as heavier industrial environments where CAT IV rated instruments are required by safety protocol.

Key Features

• Detects AC voltage from 50 to 1000 volts without direct contact
• CAT IV 1000V safety rating for use in the most demanding electrical environments
• Built-in bright LED work light for use in dark or confined spaces
• Green power-on indicator confirms detector is operational before each use
• Durable probe tip designed for repeated outlet and terminal testing

Compatibility

Designed for general non-contact AC voltage detection across residential, commercial, and industrial electrical systems operating between 50 and 1000V AC.

Installation Notes

This tool is intended for use by qualified electricians and trained technicians familiar with electrical safety procedures. Always verify the detector is functioning using the green power-on indicator before testing any circuit. Follow NFPA 70E and applicable NEC guidelines for approach boundaries and personal protective equipment when working near energized conductors. Do not use this detector on DC voltage sources, as it is rated for AC voltage detection only.