Miller MFS-OGC1-02/20FT Self-retracting Lifeline 420 Lb 20 Ft

Product Description

The MILLER MFS-OGC1-02/20FT is a single-leg self-retracting lifeline (SRL) designed for fall protection in elevated work environments. It features a 20-foot galvanized steel cable with a 3/16-inch diameter that spools and retracts automatically, keeping slack out of the system and reducing fall distance. The housing is constructed from high-impact resistant nylon for durability on job sites. Rated to 420 lb capacity and compliant with ANSI Z359.14-2021 Class 1 and OSHA standards, this SRL is intended for installation and use by qualified safety-trained workers and competent persons overseeing fall protection programs.

This self-retracting lifeline is suited for residential and commercial construction, industrial maintenance, steel erection, and general elevated work where OSHA-regulated fall protection is required. The unit connects to an anchorage point via a load-indicating swivel snap hook, which provides a visual confirmation of proper engagement. The user-end connector is a steel self-locking carabiner. The single-leg configuration makes it appropriate for straightforward vertical and overhead anchor setups.

Key Features

• 420 lb capacity rating for fall arrest applications
• 20-foot galvanized steel cable, 3/16-inch diameter, with automatic retraction
• High-impact resistant nylon housing for job-site durability
• Steel self-locking carabiner at the user connection end
• Load-indicating swivel snap hook at the anchorage connection for engagement verification
• Compliant with ANSI Z359.14-2021 Class 1 and OSHA fall protection requirements

Compatibility

Designed as a single-leg self-retracting lifeline for use with compatible full-body harness dorsal D-rings and rated anchorage points meeting ANSI Z359 requirements. Specific harness or system compatibility was not stated in available product data.

Installation Notes

Installation and inspection must be performed by a competent person as defined by OSHA 29 CFR 1926 Subpart M. Before connecting, verify that the anchorage point is rated for fall arrest loads and that the total fall clearance below the worker is sufficient for the SRL travel distance plus deceleration distance. Inspect the cable, housing, and connectors for wear, corrosion, or damage before each use. Remove the unit from service immediately if it has arrested a fall, and return it to the manufacturer or a qualified inspector before reuse.