Merit Brass 8024-550 Aluminum Pipe Nipple Sch 40

Product Description

The MERIT BRASS 8024-550 is a Schedule 40 aluminum pipe nipple measuring 1-1/2 inches in diameter and 5-1/2 inches in length, machined from 6061 aluminum alloy and threaded on both ends. It serves as a short-run connector between fittings, valves, or equipment ports in piping assemblies where corrosion resistance and reduced weight are priorities over steel. The 6061 alloy offers a solid combination of machinability and structural integrity, making it suitable for plumbing, pneumatic, and light industrial applications. Plumbers, pipefitters, and industrial maintenance technicians are the primary installers of this component.

This nipple is used in residential and light commercial piping systems where aluminum is specified for corrosion resistance or weight reduction. It is appropriate for use in air, water, and other compatible fluid systems that permit aluminum pipe fittings under the applicable system design requirements. The threaded-on-both-ends configuration makes it a direct-connect solution between two female-threaded ports without the need for additional adapters.

Key Features

• 6061 aluminum alloy construction for corrosion resistance and light weight
• Schedule 40 wall thickness for standard-duty pressure applications
• Threaded on both ends for straightforward installation between female-threaded fittings or ports
• 1-1/2 inch nominal pipe size with 5-1/2 inch overall length
• Suitable for air, water, and compatible fluid service in aluminum-approved systems

Compatibility

Designed as an OEM-style replacement or new-installation component for 1-1/2 inch NPT piping assemblies that call for Schedule 40 aluminum pipe nipples with threading on both ends.

Installation Notes

Installation is performed by licensed plumbers or pipefitters following applicable IPC or system-specific piping codes. Shut off and depressurize the system completely before removing or installing any threaded pipe components. Apply an appropriate thread sealant or PTFE tape rated for use with aluminum fittings and the fluid being conveyed. Avoid over-tightening, as aluminum threads can gall or strip more readily than steel when excessive torque is applied.