Merit Brass 8024-250 Aluminum Pipe Nipple Sch 40

Product Description

The MERIT BRASS 8024-250 is a Schedule 40 aluminum pipe nipple machined from 6061 aluminum alloy, measuring 1-1/2 inches nominal pipe size by 2-1/2 inches in length. It is threaded on both ends for direct connection into standard NPT fittings, valves, or pipe assemblies. At 0.17 pounds, it is lightweight without sacrificing the strength expected in Schedule 40 wall thickness. Plumbers, pipefitters, and industrial maintenance technicians install this nipple in fluid transfer, compressed air, and process piping applications where corrosion resistance and reduced weight are priorities over iron or steel alternatives.

This pipe nipple suits residential, commercial, and light industrial systems where aluminum piping is specified. Its 6061 alloy construction provides good machinability and weld compatibility, making it a practical choice for compressed air lines, irrigation headers, chemical-resistant fluid systems, and similar applications. The short 2-1/2 inch body is commonly used to make close connections between fittings or to extend a threaded port with minimal run length. OSHA-compliant construction makes it appropriate for workplace and industrial installations as well.

Key Features

• 6061 aluminum alloy construction for corrosion resistance and lightweight performance
• Schedule 40 wall thickness for standard-duty pressure applications
• Threaded on both ends for direct NPT fitting connections
• 1-1/2 inch nominal pipe size by 2-1/2 inch body length
• Weighs 0.17 pounds, significantly lighter than equivalent steel nipples
• OSHA-compliant standards

Compatibility

Designed as an OEM-style replacement or new-installation component for 1-1/2 inch NPT threaded piping systems requiring Schedule 40 aluminum nipples.

Installation Notes

Installation is performed by licensed plumbers or pipefitters following applicable IPC or OSHA guidelines. Always depressurize and drain the line before removing or installing nipples. Use thread sealant or PTFE tape rated for the service medium and apply it to the male threads only. Do not overtighten aluminum fittings into ferrous threaded ports, as galling or thread damage can result.