Merit Brass 8016-500 Aluminum Pipe Nipple 1x5 in Sch 40

Product Description

The MERIT BRASS 8016-500 is a Schedule 40 aluminum pipe nipple machined from 6061 aluminum alloy and threaded on both ends. It measures 1 inch nominal diameter by 5 inches in length. This nipple is designed for use in piping assemblies where a corrosion-resistant, lightweight alternative to steel or brass is required. Plumbers, pipefitters, and mechanical contractors install this type of fitting to extend or connect threaded pipe runs in fluid and air distribution systems. The 6061 alloy provides a solid balance of strength and machinability suitable for moderate-pressure service.

This pipe nipple is suited for residential and commercial piping applications including compressed air, water supply, and industrial fluid transfer lines where aluminum construction is specified or preferred. The Schedule 40 wall thickness meets standard pressure ratings for most low- to moderate-pressure service conditions. It is typically installed at threaded unions, valves, and equipment connections where a short rigid extension is needed between fittings.

Key Features

• 6061 aluminum alloy construction for corrosion resistance and reduced weight compared to steel
• Threaded on both ends for direct connection to standard NPT fittings and valves
• Schedule 40 wall thickness for moderate-pressure service
• 1 inch nominal diameter by 5 inches in length
• Complies with OSHA standards
• Lightweight at 0.28 pounds, reducing load on hanging or suspended pipe runs

Compatibility

Designed as an OEM-style replacement or new-installation component compatible with standard 1 inch NPT threaded fittings, valves, and pipe connections in Schedule 40 piping systems.

Installation Notes

Installation is typically performed by a licensed plumber or pipefitter following applicable IPC and OSHA guidelines. Apply thread sealant tape or pipe compound rated for the conveyed medium before making up the joint. Do not over-torque aluminum threads, as the alloy is softer than steel and susceptible to galling or thread damage. Shut off and depressurize the system completely before removing or installing any threaded pipe component.