Merit Brass 8012-300 Aluminum Pipe Nipple Sch 40 6061

Product Description

The MERIT BRASS 8012-300 is a Schedule 40 aluminum pipe nipple machined from 6061-grade aluminum alloy. It measures 3/4 inch nominal pipe size by 3 inches in length and is threaded on both ends for standard NPT connections. This nipple is used to extend, connect, or offset threaded pipe runs in plumbing, pneumatic, and industrial piping systems. The 6061 aluminum construction keeps weight low while providing adequate strength and corrosion resistance for a wide range of non-ferrous compatible applications. Plumbers and pipefitters install this nipple where steel or brass would add unnecessary weight or where aluminum compatibility is required by the system design.

This pipe nipple fits residential and light commercial piping applications where Schedule 40 aluminum is specified. It is well suited for pneumatic lines, irrigation systems, compressed air distribution, and industrial process piping where aluminum is an acceptable material. The 3/4 inch nominal size is one of the most common sizes in these systems, making this nipple a straightforward replacement or extension fitting. Installation is typically performed by licensed plumbers or pipefitters following applicable code requirements for the system type.

Key Features

• 6061 aluminum alloy construction for lightweight, corrosion-resistant service
• Schedule 40 wall thickness for standard-duty threaded pipe applications
• Threaded on both ends for direct NPT connection to fittings, valves, or pipe
• 3/4 inch nominal pipe size fits common system configurations
• OSHA standards compliance noted for applicable workplace piping installations

Compatibility

Designed as a standard Schedule 40 aluminum pipe nipple for use with 3/4 inch NPT threaded fittings and piping components in non-ferrous compatible systems.

Installation Notes

Installation is performed by a licensed plumber or pipefitter. Depressurize and isolate the line before removing any existing fittings or nipples. Use thread sealant or PTFE tape rated for the service fluid on all threaded connections. Do not overtighten aluminum threaded fittings, as the alloy is softer than steel and susceptible to thread damage from excessive torque.