Merit Brass 6024-6000 Ss Pipe Nipple 1-1/2 in 316 316L Sch 40

Product Description

The MERIT BRASS 6024-6000 is a welded stainless steel pipe nipple rated for 1-1/2 inch pipe in Grade 316/316L material at Schedule 40 wall thickness. This nipple is used to extend or connect threaded pipe runs in demanding fluid and gas piping systems. The dual-grade 316/316L designation means the fitting meets both standard and low-carbon corrosion resistance requirements, making it suitable for wet, chemical-exposed, or marine environments. Licensed plumbers and pipefitters typically specify this type of fitting where carbon steel or brass would corrode prematurely. At 12.7 pounds, this is a substantial, full-size nipple built to handle the mechanical and pressure demands of commercial and industrial Schedule 40 systems.

This nipple is suited for use in residential, commercial, and light industrial piping applications where corrosion resistance and pressure integrity are required. Typical install scenarios include process water lines, chemical transfer systems, marine plumbing, food-service piping, and HVAC hydronic systems where stainless fittings are called out by spec. It threads directly into Schedule 40 stainless or compatible carbon steel fittings using standard NPT engagement. Welded construction provides uniform wall integrity throughout the fitting body without the inconsistencies sometimes found in seamless alternatives at this size.

Key Features

• Grade 316/316L dual-certified stainless steel for superior corrosion resistance in wet and chemical environments
• Schedule 40 wall thickness for compatibility with standard NPT threaded pipe systems
• Welded construction delivers consistent wall integrity across the full fitting length
• 1-1/2 inch pipe size fits standard trade-supply fittings and valves without adapters
• Low-carbon 316L grade minimizes sensitization risk in welded assemblies

Compatibility

Designed as an OEM-style replacement and standard-service pipe nipple for 1-1/2 inch Schedule 40 stainless steel NPT threaded piping systems.

Installation Notes

Installation should be performed by a licensed plumber or qualified pipefitter following applicable IPC and local mechanical code requirements. Shut off and depressurize the line completely before removing or installing any threaded pipe fitting. Apply an appropriate thread sealant or PTFE tape rated for the service fluid before making up the joint. Do not over-torque threaded stainless fittings, as galling can occur on stainless-to-stainless connections without proper lubrication or anti-seize compound.