Merit Brass 2016-7200 Brass Pipe Nipple 72 in 1 in Npt

Product Description

The MERIT BRASS 2016-7200 is a full-length red brass pipe nipple threaded on both ends, designed for connecting pipe sections in plumbing, HVAC, gas distribution, and industrial fluid systems. At 72 inches overall length with 1-inch NPT threads, this nipple handles applications where standard close or short nipples fall short. Red brass construction offers reliable corrosion resistance in water, gas, and mild chemical service. Plumbers and pipefitters install this nipple where a long, rigid threaded run is needed without additional couplings. The part weighs 9.22 pounds and ships as a single piece.

This nipple suits residential and light commercial installations where a continuous threaded brass section is required between fittings or equipment connections. Common applications include water supply lines, compressed air headers, steam systems, and gas piping where the 1-inch NPT thread size is specified. The 72-inch length makes it particularly useful for through-wall or between-floor runs that benefit from a single threaded section rather than multiple joined pieces.

Key Features

• 72-inch overall length provides extended reach in a single threaded piece
• Red brass construction resists corrosion in water, gas, and mild chemical service
• Threaded on both ends with 1-inch NPT for standard mating to fittings and valves
• NPT taper thread seals reliably with pipe thread sealant or PTFE tape
• Single-piece design eliminates mid-run coupling points

Compatibility

Designed as an OEM-style replacement or new-installation component for 1-inch NPT piping systems using standard threaded brass fittings, valves, and couplings.

Installation Notes

Installation is performed by licensed plumbers or pipefitters following applicable local codes, IPC, or IFGC requirements depending on the service medium. Shut off and depressurize the supply line fully before threading or removing any pipe section. Apply listed pipe thread sealant or PTFE tape to male threads before assembly. Do not over-tighten; use a pipe wrench with a backup wrench on the adjacent fitting to avoid stressing connected components.