Merit Brass 2016-300BSPT Brass Pipe Nipple 1 in Bspt

Product Description

The MERIT BRASS 2016-300BSPT is a red brass pipe nipple threaded on both ends, designed for use in fluid and gas piping systems where a short, fully threaded connector is needed between fittings, valves, or equipment. The nipple measures 3 inches overall length with a 1-inch outside diameter and carries a 1-inch BSPT thread standard. Red brass construction provides good corrosion resistance in water, steam, and mild chemical service. This component is typically installed by licensed plumbers or pipefitters working on commercial or light industrial piping assemblies.

This nipple fits applications where British Standard Pipe Taper threads are specified, common in imported equipment, pumps, manifolds, and plumbing fixtures requiring BSPT connections. The 3-inch overall length makes it suitable for close-coupled connections where a standard hex nipple would be too short but a longer close nipple is not needed. It meets OSHA standards as noted by the manufacturer. Installers working on domestic or process water lines, steam distribution, or compressed air systems with BSPT-threaded ports will find this a direct-fit connector.

Key Features

• Threaded on both ends across full 3-inch overall length
• 1-inch BSPT thread standard for compatibility with metric and import equipment
• Red brass material offers corrosion resistance in water, steam, and mild chemical service
• 1-inch outside diameter matching standard 1-inch iron pipe size
• Meets OSHA standards
• Sold individually — no minimum beyond single-unit purchase

Compatibility

Designed as an OEM-style replacement or repair fitting for piping systems that use 1-inch BSPT-threaded connections, including valves, pumps, manifolds, and equipment ports specifying British Standard Pipe Taper threading.

Installation Notes

Installation should be performed by a licensed plumber or pipefitter in accordance with applicable local plumbing codes and the IPC. Shut off and depressurize the system before removing any existing fittings. Apply an appropriate thread sealant or PTFE tape rated for the service fluid before making up the joint. Do not over-torque brass fittings, as this can crack the material — hand-tight plus a moderate wrench turn is standard practice for brass nipples.