Merit Brass 2008-2400 Brass Pipe Nipple 1/2 Npt 24 in

Product Description

The MERIT BRASS 2008-2400 is a red brass pipe nipple threaded on both ends, designed for use in plumbing, gas distribution, and fluid-handling systems. At 24 inches overall length with 1/2 inch NPT threads on each end and a 1/2 inch outside diameter, this nipple provides a full-length threaded connection between fittings, valves, or pipe assemblies. Red brass construction delivers strong corrosion resistance in water service applications. Weighing 1.62 pounds, it is sized for standard iron pipe fittings and meets OSHA requirements. Plumbers and pipefitters install this nipple where extended close-coupled connections are required.

This nipple is suited for residential and light commercial plumbing, hydronic heating, compressed air lines, and low-pressure gas supply where 1/2 inch NPT connections are standard. The 24-inch length makes it a practical choice for drop legs, riser extensions, and inline connections between components spaced further apart than a standard close or short nipple would cover. Its red brass alloy composition makes it compatible with potable water systems where dezincification resistance is important.

Key Features

• Red brass construction for corrosion resistance in water and fluid service
• Threaded on both ends with 1/2 inch NPT for compatibility with standard iron pipe fittings
• 24-inch overall length suits riser extensions and drop leg installations
• Meets OSHA standards
• 1/2 inch outside diameter consistent with standard IPS pipe sizing

Compatibility

Designed as an OEM-style replacement or new-install component for any 1/2 inch NPT plumbing or piping assembly requiring a threaded brass nipple.

Installation Notes

Installation is performed by a licensed plumber or pipefitter. Shut off the water supply or gas service and depressurize the line before threading the nipple into place. Apply appropriate thread sealant or PTFE tape to the NPT threads per local plumbing code and the International Plumbing Code or International Fuel Gas Code as applicable. Do not over-tighten; use a pipe wrench sized for 1/2 inch pipe and follow standard hand-tight-plus-turns practice per the fitting manufacturer guidance.