Merit Brass 2008-200BSPT Brass Pipe Nipple 1/2 in Bspt

Product Description

The MERIT BRASS 2008-200BSPT is a red brass pipe nipple threaded on both ends, designed for use in fluid and gas piping systems where BSPT (British Standard Pipe Taper) thread engagement is required. With an overall length of 2 inches and a 1/2-inch outside diameter, this close nipple delivers full threading from end to end, allowing direct coupling between fittings or valves without exposed plain pipe. Red brass construction provides corrosion resistance suitable for water, steam, and mild chemical service lines. Plumbers and pipefitters specify this nipple where metric or British-standard threaded connections are called out in the system design.

This nipple is suited for residential and light commercial plumbing, hydronic heating, compressed air, and general industrial piping applications where BSPT threaded fittings are used. The 1/2-inch iron pipe size makes it a common selection for supply branches, fixture connections, and instrumentation tie-ins. It meets OSHA standards and carries UNSPSC Code 40173300 for procurement classification. Sold individually, it is appropriate for single-unit replacement or new installation work.

Key Features

• Threaded on both ends for direct fitting-to-fitting connections
• 2-inch overall length — compact close nipple profile
• 1/2-inch BSPT thread standard for British-standard piping systems
• Red brass material for corrosion resistance in water and steam service
• OSHA compliant
• 1/2-inch iron pipe size — common branch and fixture connection size

Compatibility

Designed for use with 1/2-inch BSPT threaded fittings, valves, and couplings in piping systems specified to British Standard Pipe Taper thread forms.

Installation Notes

Installation is performed by licensed plumbers or pipefitters. Shut off the water supply or depressurize the line before removing or installing any nipple. Apply appropriate thread sealant or PTFE tape to BSPT threads before assembly, as BSPT is a tapered thread that seals on the thread form. Do not overtighten, as brass fittings are susceptible to cracking under excessive torque.