Merit Brass 01613-9632 Eccentric Reducer 6x2 in 316L Ss

Product Description

The MERIT BRASS 01613-9632 is a 6 x 2 inch eccentric reducer fitting designed for butt weld installation in industrial and commercial piping systems. Manufactured from 316L stainless steel, this Schedule 10 fitting transitions a 6 inch pipe down to a 2 inch pipe with an offset centerline, which helps maintain flow at the bottom of the pipe and simplifies venting in liquid service lines. The 316L alloy provides low carbon content for improved resistance to intergranular corrosion after welding. Licensed welders and pipe fitters working in process, mechanical, or utility piping installations are the primary installers.

This eccentric reducer is suited for use in commercial and industrial piping systems where maintaining a consistent bottom-of-pipe elevation is required, such as pump suction lines, process fluid transfer, and drainage-critical runs. The butt weld end connections on both ends make it compatible with Schedule 10 stainless steel pipe in the corresponding sizes. Applications span HVAC chilled water systems, plumbing mains, and light industrial process lines where corrosion resistance and weld integrity are priorities.

Key Features

• 316L stainless steel construction for superior corrosion resistance and low-carbon weld performance
• Eccentric design keeps the bottom of the pipe flush, supporting proper drainage and pump suction alignment
• Butt weld x butt weld end connections on both ends for a full-penetration, high-integrity joint
• Schedule 10 wall thickness suitable for moderate-pressure commercial and industrial service
• Reduces from 6 inches to 2 inches in a single fitting, eliminating the need for multiple transition pieces

Compatibility

Designed as an OEM-style butt weld eccentric reducer for Schedule 10 stainless steel piping systems using 6 inch and 2 inch nominal pipe sizes.

Installation Notes

Installation must be performed by a qualified pipe welder or certified pipe fitter following applicable codes such as ASME B31.1 or B31.3 for process and power piping. Depressurize and drain the piping system fully before cutting into any existing line. Proper fit-up, tacking, and full butt weld procedures are required to ensure joint integrity and avoid warping in the 316L material. Post-weld passivation or cleaning may be required depending on the service environment and applicable project specifications.