Merit Brass 01613-3220 Eccentric Reducer 2x1-1/4 in 316L Ss

Product Description

The MERIT BRASS 01613-3220 is a Schedule 10 eccentric reducer designed for butt weld installation in stainless steel piping systems. Manufactured from 316L stainless steel, this fitting transitions a 2-inch pipe down to a 1-1/4-inch pipe with an offset centerline, keeping the flat side aligned to prevent air pockets or sediment traps in horizontal runs. It weighs 0.665 pounds and is suited for process piping, industrial plumbing, and sanitary or corrosion-resistant fluid handling applications. Plumbers, pipefitters, and mechanical contractors install this fitting where a concentric reducer would cause drainage or venting issues in horizontal lines.

This eccentric reducer is used in residential and commercial piping systems where Schedule 10 wall thickness meets pressure and flow requirements. It is a common choice for process lines, chemical handling, food-grade installations, and marine or coastal environments where 316L stainless steel provides superior chloride corrosion resistance over standard 304-grade material. The butt weld end connections integrate directly into welded pipe assemblies for a clean, full-penetration joint.

Key Features

• 316L stainless steel construction for enhanced corrosion resistance in harsh and chloride-heavy environments
• Eccentric design keeps the flat side consistent to prevent air locks in horizontal pipe runs
• Butt weld x butt weld end connections for full-penetration, high-integrity joints
• Schedule 10 wall thickness suitable for low-to-moderate pressure piping systems
• 2 x 1-1/4 inch transition size for standard pipe reduction applications

Compatibility

Designed as an OEM-style replacement or new-installation fitting for Schedule 10 stainless steel butt weld piping systems with 2-inch inlet and 1-1/4-inch outlet connections.

Installation Notes

Installation must be performed by a qualified pipefitter or plumber following applicable codes such as ASME B31.3 for process piping or local mechanical codes. Shut down and depressurize the piping system completely before cutting in or replacing any fitting. Butt weld connections require proper fit-up, purge backing where required by the weld procedure, and inspection per the governing weld standard. Do not substitute this Schedule 10 fitting in systems that require heavier wall schedules without verifying pressure ratings.