Merit Brass 01413-3208 Eccentric Reducer 2x1/2 in 304L Ss

Product Description

The MERIT BRASS 01413-3208 is a 304L stainless steel eccentric reducer designed to connect pipe sections of different diameters while maintaining a flat side along one plane. This fitting transitions from a 2-inch pipe to a 1/2-inch pipe using butt weld end connections on both ends, making it suitable for welded piping systems where alignment and flow control are critical. Built to Schedule 10 wall thickness, it is commonly installed by licensed plumbers and pipefitters working in process, industrial, or commercial piping systems. The 304L low-carbon stainless steel grade offers good corrosion resistance and is well suited for sanitary, chemical, and food-grade environments.

This eccentric reducer is used in piping systems where the flat bottom alignment of an eccentric fitting is required to prevent air pockets in liquid lines or to allow full drainage in horizontal runs. Typical applications include process piping, industrial fluid handling, and commercial plumbing installations where Schedule 10 stainless fittings are specified. It is appropriate for both above-ground and in-wall or in-ceiling mechanical systems where a welded connection is preferred over threaded or press-fit alternatives.

Key Features

• Eccentric design maintains a flat side to support proper drainage and air elimination in horizontal pipe runs
• 304L low-carbon stainless steel construction provides corrosion resistance and weldability
• Butt weld connections on both ends for a strong, permanent joint
• Schedule 10 wall thickness for lightweight yet durable piping installations
• 2 inch to 1/2 inch size transition accommodates significant diameter reductions in a single fitting

Compatibility

Designed as an OEM-style replacement or new-installation fitting for Schedule 10 stainless steel butt weld piping systems requiring a 2 inch by 1/2 inch eccentric reduction.

Installation Notes

Installation requires a qualified pipefitter or welder certified for stainless steel butt weld procedures. Depressurize and drain the system fully before cutting into any existing piping. Follow applicable codes including ASME B16.9 for butt weld fittings and local plumbing or mechanical codes. Use appropriate purge gas and filler material rated for 304L stainless steel to avoid sensitization at the weld zone.