Merit Brass 01413-1608 Eccentric Reducer 304L Ss Butt Weld Sch 10

Product Description

The MERIT BRASS 01413-1608 is a Schedule 10 eccentric reducer fitting designed to transition pipe diameters from 1 inch to 1/2 inch while keeping one side of the pipe run flat. Constructed from 304L stainless steel, this fitting offers good corrosion resistance in a wide range of piping applications. Both ends use butt weld connections, creating a strong, continuous weld joint suited for permanent installations. At 0.24 pounds, it is a compact, lightweight component. Licensed plumbers and pipefitters are the typical installers for this type of fitting in process, industrial, and commercial piping systems.

This eccentric reducer is appropriate for residential, commercial, and light industrial piping systems where a diameter reduction is needed without creating a low point that could trap fluid or gas. The eccentric offset keeps the bottom of the pipe level, which is important in horizontal runs where drainage or flow consistency matters. Schedule 10 wall thickness makes it suitable for moderate-pressure service in stainless steel piping configurations. It is sold individually with a minimum order quantity of one.

Key Features

• Eccentric design maintains a flat bottom for proper drainage alignment in horizontal pipe runs
• 304L stainless steel construction provides corrosion resistance and weldability in demanding environments
• Butt weld end connections on both ends for secure, leak-resistant permanent joints
• Schedule 10 wall thickness suitable for moderate-pressure piping service
• Lightweight at 0.24 pounds for easy handling during installation

Compatibility

Designed as an OEM-style replacement or new-installation fitting for Schedule 10 stainless steel butt weld piping systems requiring a 1 inch to 1/2 inch eccentric reduction.

Installation Notes

Installation should be performed by a qualified pipefitter or licensed plumber following applicable codes such as the International Plumbing Code or ASME B31 piping standards. Isolate and depressurize the pipe system completely before cutting into any existing line. Butt weld connections require proper fit-up, purge gas, and qualified welding procedures to achieve full-penetration welds on stainless steel. Verify the eccentric offset orientation before tacking to ensure the flat side aligns with the intended drainage or flow direction.