Megapress 25341 Reducing Pipe Tee 1x1x3/4 in Press Carbon Steel

Product Description

The MEGAPRESS 25341 is a carbon steel reducing pipe tee designed for use in gas piping systems installed with press-style connections. Part of the MegaPressG system, this fitting is compatible with Schedule 5 through Schedule 40 black iron pipe and connects without cutting oils, open flame, or threading. The three-port configuration reduces from 1 inch on both run outlets to 3/4 inch on the branch. It carries a temperature rating of -40 to 180 degrees F, making it suitable for a range of commercial and residential gas distribution applications. Licensed plumbers and pipefitters are the primary installers of this fitting.

This reducing tee is designed for use in black iron pipe gas systems where a branch takeoff with a size reduction is required. The press connection end style speeds up installation compared to threaded or welded alternatives, which is especially useful in retrofit and service work where torch use is restricted or impractical. It is suited for residential and light commercial gas piping where Schedule 5 through Schedule 40 pipe is present.

Key Features

• Press-style connections eliminate threading, cutting oils, and open-flame joining
• Compatible with Schedule 5 through Schedule 40 black iron pipe
• Reducing tee configuration: 1 x 1 x 3/4 inches nominal
• Carbon steel construction rated for gas service
• Temperature range: -40 to 180 degrees F
• Reduces installation time in gas piping retrofit and new construction

Compatibility

Designed for use with the MegaPressG press system on Schedule 5 through Schedule 40 black iron pipe in gas piping applications.

Installation Notes

Installation must be performed by a licensed plumber or pipefitter in accordance with applicable local codes and IFGC requirements. Shut off and properly purge the gas supply before beginning any work on the piping system. Press connections require the correct jaw and ring tool approved for the MegaPressG system — using unapproved tooling may result in an incomplete or unsafe joint. Verify all connections with an approved leak detection method after system repressurization.