Mechanix Wear SMP-C91-009 Cut Resistant Gloves Size M

Product Description

The MECHANIX WEAR SMP-C91-009 is a cut-resistant work glove rated ANSI/ISEA Cut Level A5 and ANSI Abrasion Level 3, built for trade professionals working around sharp materials, sheet metal, glass, or abrasive surfaces. The palm, fingers, and thumb saddle are reinforced with ArmorTex material, providing durable cut and abrasion protection where hands take the most punishment. A synthetic leather construction keeps the glove lightweight and flexible while a TrekDry back material promotes airflow and moisture management during extended wear. Overall length is 10 inches, and the glove ships as a single pair in size Medium.

This glove suits HVAC technicians handling sheet metal ductwork, electricians routing conduit through tight spaces, plumbers working with copper fittings or strapping, and general mechanical trades where cut exposure is routine. The Hook and Loop cuff style allows a secure, adjustable fit over wrist cuffs or sleeves. The EN 388 rating of 3544 confirms independent laboratory testing for abrasion, cut, tear, and puncture resistance, making this a documented choice for job-site PPE compliance programs in both residential and light commercial settings.

Key Features

• ANSI/ISEA Cut Level A5 protection via ArmorTex cut lining
• ANSI Abrasion Resistance Level 3 for high-wear palm and finger zones
• ArmorTex reinforcement covers palm, fingers, and thumb saddle
• TrekDry back material for breathability and moisture control
• Hook and Loop cuff for adjustable, secure wrist closure
• EN 388 rating 3544 — independently tested for abrasion, cut, tear, and puncture

Compatibility

Sized for Men's Medium or Women's Large hand sizing. Designed as a general-purpose cut-resistant glove for trade and industrial applications where ANSI Cut A5 hand protection is required.

Installation Notes

Inspect gloves before each use for cuts, abrasions, or degraded stitching that could compromise cut protection. Replace immediately if the ArmorTex lining shows visible wear-through. PPE selection should comply with the applicable OSHA hand protection standard (29 CFR 1910.138) and any site-specific safety plan. These gloves do not provide electrical arc flash protection and should not be used as a substitute for rated electrical PPE.