Mechanix Wear S5EP-03-011 Cut Resistant Gloves 2XL A7

Product Description

The MECHANIX WEAR S5EP-03-011 is a high-cut and puncture-resistant work glove engineered for trade professionals who face sharp edges, abrasive surfaces, and puncture hazards on the job. Built from an 18-gauge HPPE blend shell with a palm-and-finger nitrile dip coating, this glove meets ANSI/ISEA Cut Level A7, ANSI/ISEA Puncture Level 3, and ANSI/ISEA Abrasion Level 4. The textured nitrile coating provides grip in both dry and lightly oily conditions. The seamless HPPE lining reduces interior friction and hot spots during extended wear. Sized for 2XL men or 3XL women, this is a paired set sold as a single pair. Machine washable construction supports repeated use in demanding field environments.

This glove is suited for residential and commercial trade work involving sheet metal handling, conduit installation, glass handling, demolition, and general mechanical assembly. The nitrile palm coating performs well in environments where grip and cut protection must coexist. The knit cuff helps seal out debris at the wrist. The thermo plastic rubber back material adds durability and mild impact protection on the dorsal side. Electricians, HVAC technicians, plumbers, and general construction trades will find this glove appropriate for tasks where ANSI A7 cut resistance is specified by site safety requirements.

Key Features

• ANSI/ISEA Cut Resistance Level A7 for protection against high-cut-risk materials
• ANSI/ISEA Puncture Resistance Level 3 with nitrile palm-and-finger coating
• ANSI/ISEA Abrasion Resistance Level 4 for extended surface contact durability
• 18-gauge seamless HPPE blend lining reduces interior wear and hot spots
• Textured nitrile dip coating delivers grip on dry and lightly oily surfaces
• Machine washable design supports repeated use and extended service life
• EN 388 rated 4X42F and compliant with ANSI 138 standards

Compatibility

Designed as a general-purpose cut-resistant glove for trade professionals in HVAC, plumbing, electrical, and construction applications requiring ANSI/ISEA Cut Level A7 hand protection.

Installation Notes

Inspect gloves before each use for cuts, tears, or coating separation that may compromise protection. Follow the job-site PPE requirements and applicable OSHA hand protection standards when selecting and wearing cut-resistant gloves. Machine wash according to manufacturer care instructions and allow to air dry before reuse. Replace gloves when the shell or coating shows visible damage or degradation.