Mechanix Wear NSIND-91-012 Cut Resistant Gloves 2XL A5

Product Description

The MECHANIX WEAR NSIND-91-012 is a full-fingered, cut- and puncture-resistant work glove built for trade professionals working around sharp edges, sheet metal, conduit, and abrasive materials. Rated ANSI/ISEA Cut Level A5 and Puncture Level 5, the glove uses a Durahide leather palm with an ArmorCore back for multi-directional protection. The gauntlet-style cuff extends coverage up the wrist, and the high-visibility yellow coloring improves jobsite visibility. Overall length is 13 inches. Sold as a pair, this glove is sized 2X-Large and is installed by the worker before handling sharp materials in HVAC, electrical, plumbing, or general mechanical service environments.

This glove is suited for residential and commercial trade applications where hand protection against cuts, punctures, and abrasion is required. Typical use cases include handling sheet metal ductwork, pulling wire through conduit, working with insulation, and general mechanical assembly. The padded palm and soft textured grip surface support tool handling and repetitive gripping tasks. The gauntlet cuff adds wrist-level protection in environments with debris or sharp edges. ANSI Abrasion Level 4 and EN 388 rating 4X43E confirm multi-hazard suitability across common trade scenarios.

Key Features

• ANSI/ISEA Cut Resistance Level A5 for protection against sharp edges and sheet metal
• ANSI/ISEA Puncture Resistance Level 5 with ArmorCore back material
• Durahide leather palm with padded grip surface for durability and tool control
• Gauntlet cuff in high-visibility yellow for extended wrist coverage and jobsite visibility
• EN 388 rated 4X43E and meets ASTM F2878 Level 2 standards
• ANSI Abrasion Resistance Level 4 for use on rough or abrasive surfaces

Compatibility

Designed as an OEM-style personal protective equipment glove for trade professionals requiring ANSI Cut Level A5 and Puncture Level 5 hand protection in mechanical, electrical, HVAC, and plumbing service environments.

Installation Notes

These gloves are donned by the worker prior to beginning any task involving sharp materials, cutting tools, or abrasive surfaces. Inspect gloves before each use for cuts, punctures, or delamination that would reduce protection. Follow your employer safety program and applicable OSHA 29 CFR 1910.138 requirements for hand protection selection. Do not use damaged gloves or substitute a lower-rated glove when the task requires A5 cut protection.