Mcr Safety PD6951XXL Cut Resistant Gloves A6 2XL

Product Description

The MCR SAFETY PD6951XXL is a cut, puncture, and abrasion-resistant work glove built for trade professionals who handle sharp-edged materials, sheet metal, glass, or heavy pipe. The glove shell is constructed from Hypermax HPPE fiber and features a polyurethane palm coating for grip and dexterity. It meets ANSI/ISEA A6 cut resistance, level 4 puncture resistance, and level 5 abrasion resistance. The high-visibility yellow color helps with hand visibility in low-light or busy work environments. A TPR back adds an additional layer of impact and abrasion protection. This is a unisex 2X-Large pair designed for extended wear during demanding installation and service tasks.

These gloves are well-suited for HVAC sheet metal work, electrical conduit handling, plumbing rough-in, pipe fitting, and general mechanical service. The knit construction and palm-only coating preserve finger sensitivity for tasks requiring fine motor control, such as threading fittings, pulling wire, or handling small hardware. The unlined interior allows for a close fit and breathability during active work. At 11 inches in overall length, the extended cuff provides added wrist coverage in applications where forearm protection matters.

Key Features

• ANSI/ISEA A6 cut resistance rating for high-risk cutting and handling tasks
• Level 4 puncture resistance for protection against sharp points and wire ends
• Level 5 abrasion resistance for durability against rough surfaces
• Polyurethane palm coating delivers grip and tactile sensitivity
• TPR back panel adds impact and dorsal abrasion protection
• High-visibility yellow color for hand awareness in active work zones
• 11-inch overall length for extended wrist and cuff coverage

Compatibility

Designed as a general-purpose cut and puncture protection glove for trade professionals in HVAC, plumbing, electrical, and mechanical service applications. Sized for unisex 2X-Large fit in both mens and womens sizing.

Installation Notes

Inspect gloves before each use for cuts, tears, or coating separation that may compromise protection. Replace immediately if the shell or coating shows visible damage. These gloves do not provide electrical arc flash or chemical splash protection and should not be used as a substitute for task-specific PPE where those hazards are present. Consult applicable OSHA hand protection requirements and employer PPE programs when selecting gloves for specific job tasks.