Mcr Safety 92783XS Cut Resistant Gloves Ansi A4 X-small

Product Description

The MCR SAFETY 92783XS is an X-Small cut, puncture, and abrasion-resistant work glove built for trade and industrial environments where hand protection against sharp edges, puncture hazards, and rough surfaces is required. The glove features a 13-gauge HyperMax shell with a dual-coat finish: a full gray flat nitrile base dip followed by a black foam nitrile coat on the palm and fingers. This layered construction delivers ANSI/ISEA Cut Level A4, Puncture Level 5, and Abrasion Level 4 ratings under ANSI 105 standards. The foam nitrile palm coating provides reliable grip in both wet and dry conditions. Sold as a pair, this glove is well-suited for general trades, assembly, fabrication, and maintenance work.

The 92783XS is designed for workers who handle sheet metal, glass, wire, or other sharp materials in residential and commercial trade settings. The seamless HyperMax lining and knit cuff construction allow for extended wear without excessive fatigue. The foam nitrile coating on the palm and fingertips is appropriate for tasks requiring tactile sensitivity while maintaining cut and puncture protection. Women wearing a Small size will find the X-Small an equivalent fit. The glove is unisex and suitable for electricians, HVAC technicians, plumbers, fabricators, and general maintenance crews handling potentially sharp components.

Key Features

• ANSI/ISEA Cut Resistance Level A4 per ANSI 105:2020
• ANSI/ISEA Puncture Resistance Level 5 per ANSI 105:2016
• ANSI/ISEA Abrasion Resistance Level 4 per ANSI 105:2016
• Dual-coat nitrile construction: flat nitrile base layer plus foam nitrile palm and finger coat for wet and dry grip
• 13-gauge HyperMax shell and lining with seamless interior for all-day comfort
• Tear-away cuff design with knit wrist cuff in gray

Compatibility

Designed as a direct-fit X-Small work glove in the MCR SAFETY 92783 Series, compatible with standard glove programs and PPE requirements calling for ANSI Cut A4 and Puncture Level 5 hand protection.

Installation Notes

Inspect gloves before each use for cuts, tears, or degraded coating that would compromise protection ratings. Replace immediately if the nitrile coating shows cracking, peeling, or puncture damage. These gloves are not rated as a blood-borne pathogen barrier and are not FDA approved for medical use. Consult your site safety program or applicable OSHA hand protection standard (29 CFR 1910.138) to confirm this glove meets the hazard assessment requirements for your specific task.