Mcr Safety 9277NFXL Cut Resistant Gloves Xl A7 Nitrile

Product Description

The MCR SAFETY 9277NFXL is a high-visibility, cut- and puncture-resistant work glove engineered for trade professionals who face sharp materials, rough surfaces, and low-visibility jobsite conditions. Built on a 13-gauge HyperMax seamless shell, this glove achieves ANSI/ISEA 105:2020 Cut Level A7 and ANSI/ISEA 105:2016 Puncture Level 3 ratings. The palm and fingertips are dipped in NFT nitrile foam, which adds grip and ANSI Abrasion Level 6 resistance. Sized for XL hands and offered as a paired set, this glove suits electricians, plumbers, HVAC technicians, and general construction trades handling sheet metal, conduit, pipe, and other abrasive or edged materials.

This glove is designed for use in residential and commercial trade applications where cut hazard control is required. The hi-visibility lime color improves wearer visibility on active job sites. The knit cuff provides a secure fit at the wrist, and the reinforced thumb crotch extends service life in high-wear areas. A touchscreen-compatible palm allows device use without removing the glove. This glove was formerly sold under the Memphis Glove brand and carries over the same construction and protection ratings.

Key Features

• ANSI/ISEA 105:2020 Cut Level A7 protection via 13-gauge HyperMax shell
• ANSI/ISEA 105:2016 Puncture Level 3 resistance
• ANSI/ISEA 105:2016 Abrasion Level 6 via NFT nitrile foam palm and fingertip dip
• Hi-visibility lime color for improved jobsite visibility
• Reinforced thumb crotch for extended durability in high-wear zones
• Touchscreen-compatible palm coating for device use while gloved
• Seamless HyperMax lining for comfort during extended wear

Compatibility

Designed as an OEM-style replacement glove compatible with XL hand sizing for unisex fit, also fitting women's large hands. Part of the MCR SAFETY 9277NF series.

Installation Notes

Inspect gloves before each use for cuts, tears, or coating separation that would reduce protection. Gloves should be replaced when the coating shows wear through or when cut ratings can no longer be verified. Follow applicable OSHA hand protection standards (29 CFR 1910.138) when selecting and using cut-resistant PPE. Do not use damaged gloves in active cut-hazard environments.