Mcr Safety 92728HVXXL Cut Resistant Gloves 2x-large A2

Product Description

The MCR SAFETY 92728HVXXL is a cut, puncture, and abrasion-resistant work glove engineered for trade professionals who handle sharp materials, metal components, and abrasive surfaces. Built on an 18-gauge HPPE shell with a HyperMax back and an unlined interior, this glove delivers ANSI/ISEA A2 cut resistance and Level 3 puncture and abrasion resistance ratings. The nitrile foam coating covers the palm and fingertips, providing grip on both dry and lightly oily surfaces without sacrificing dexterity. Sized at 2X-Large with a 10-inch overall length, it fits most adult hands needing a full-coverage knit cuff and hand-specific fit. HVAC technicians, plumbers, electricians, and sheet metal workers are the primary users.

This glove is suited for residential and commercial trade work where workers contact sheet metal ductwork, conduit, pipe fittings, and similar sharp-edged materials. The high-visibility lime shell with green nitrile foam coating improves worker visibility on the job site. The knit cuff style and hand-specific construction reduce hand fatigue during extended use. It is sold individually as a single pair, making it practical for replacement purchasing or initial kit-out of field technicians.

Key Features

• ANSI/ISEA A2 cut resistance rating for protection against sharp sheet metal edges and wire
• ANSI/ISEA Level 3 puncture resistance guards against fasteners, staples, and pointed hardware
• ANSI/ISEA Level 3 abrasion resistance extends glove service life on rough surfaces
• 18-gauge HPPE shell with HyperMax back balances cut protection and hand flexibility
• Nitrile foam palm and fingertip coating delivers grip on dry and lightly oily surfaces
• High-visibility lime color with hand-specific fit and knit cuff for secure wear

Compatibility

Designed as a general-purpose cut and puncture-resistant work glove for trade professionals in HVAC, plumbing, electrical, and sheet metal applications requiring ANSI/ISEA A2 cut protection.

Installation Notes

Inspect gloves before each use for cuts, tears, or coating separation that may compromise protection. Replace immediately if the shell or coating shows damage. Always don and remove gloves with hands clear of sharp edges. Glove use does not substitute for lockout/tagout or other energy-control procedures required by site safety protocols.