Mcr Safety 9188SFBS Cut Resistant Gloves A4 Small Kevlar

Product Description

The MCR SAFETY 9188SFBS is an ANSI/ISEA A4 cut-resistant, knit glove built for trade and industrial work environments where hand protection against cuts, punctures, and abrasion is required. Constructed from an 18-gauge Kevlar shell, the glove delivers a high strength-to-dexterity ratio that lets workers maintain grip and tactile feel during material handling, fabrication, and maintenance tasks. The palm and fingertips are coated with foam nitrile, which enhances grip on both dry and lightly oily surfaces. At 10 inches in overall length, the glove covers the wrist and lower forearm area for added protection. HVAC technicians, pipefitters, plumbers, and general trade workers handling sheet metal, threaded pipe, conduit, or sharp-edged components will find this glove appropriate for daily use.

The 9188SFBS is designed for right- and left-hand-specific fit in a Small (numeric size 6) configuration, making it suited for technicians and tradespeople with smaller hand profiles. The knit cuff and unlined interior allow for an extended wear period without excessive heat buildup. It fits residential and commercial service work where tasks involve handling metal components, glass fiber insulation, or other cut-hazard materials at close quarters.

Key Features

• ANSI/ISEA Cut Resistance Level A4 for protection against sharp edges and metal burrs
• ANSI/ISEA Puncture Resistance Level 2 guards against wire ends and fastener tips
• ANSI/ISEA Abrasion Resistance Level 5 for durability on rough surfaces
• 18-gauge Kevlar primary and back material provides cut protection with maintained dexterity
• Foam nitrile coating on palm and fingertips improves grip in dry and lightly oily conditions
• 10-inch overall length extends coverage past the wrist
• Hand-specific fit reduces bunching and improves tool control

Compatibility

Designed as an OEM-style work glove replacement in the MCR SAFETY 9188SFB series, sized Small (numeric size 6) for hand-specific fit in both right- and left-hand configurations.

Installation Notes

Worn PPE should be inspected before each use for tears, coating delamination, or worn-through areas that would reduce protection levels. Replace gloves that show visible damage to the Kevlar shell or foam nitrile coating. When working around rotating equipment or open flame, confirm the glove material is appropriate for that specific hazard class before use. These gloves do not provide electrical arc flash, chemical immersion, or blood-borne pathogen barrier protection.