Matco-norca mn-ftbu0402 Steel Hex Bushing 3/4 X 3/8 in

Product Description

The MATCO-NORCA mn-ftbu0402 is a forged steel hex bushing designed to reduce a 3/4 inch threaded connection down to a 3/8 inch threaded connection in pipe systems. Manufactured from ASTM A105N carbon steel using a forged construction method, this bushing delivers the mechanical strength required for demanding plumbing and gas distribution applications. The hex shoulder allows standard wrench engagement for reliable makeup and removal. Licensed plumbers and pipefitters install this fitting wherever a threaded reduction is needed without adding a separate coupling or nipple to the line.

This bushing is suited for residential and commercial pipe installations where a threaded male-to-female reduction is required in-line. Typical applications include water supply, compressed air, and low-pressure gas piping. The forged ASTM A105N steel construction makes it appropriate for systems that require material traceability and conformance to recognized material standards. It connects into any standard NPT-threaded port or pipe end at both the 3/4 inch and 3/8 inch sizes.

Key Features

• Forged ASTM A105N carbon steel construction for high mechanical integrity
• 3/4 inch to 3/8 inch threaded reduction in a single fitting
• Hex shoulder design allows wrench engagement during installation and removal
• Both connections are threaded for compatibility with standard NPT pipe and fittings
• Bushing-style fitting eliminates the need for additional couplings or nipples in a reduction

Compatibility

Designed as an OEM-style replacement and standard-service hex bushing for threaded pipe systems using 3/4 inch to 3/8 inch NPT connections.

Installation Notes

Installation should be performed by a licensed plumber or pipefitter in accordance with applicable local codes, including IPC and IFGC requirements where relevant. Shut off the system and relieve all pressure before installing or removing any threaded fitting. Apply an appropriate thread sealant or PTFE tape to the male threads before assembly. Do not over-torque; hand-tighten and then use a wrench only to the degree needed to achieve a leak-free seal.