Makita JN3201 Electric Nibbler 6 Amp 10 Gauge Metal Cutting

Product Description

The MAKITA JN3201 is a 115-volt electric nibbler designed for cutting sheet metal in fabrication, HVAC ductwork, and general metalworking applications. Rated at 6 amps and 1,300 strokes per minute (SPM), it handles mild steel up to 10 gauge and stainless steel up to 13 gauge. Ball and needle bearings support consistent stroke action under load. A lock-on switch reduces operator fatigue during extended cuts. Weighing 10.8 pounds, it is sized for one-handed use in tight access areas. Licensed sheet metal workers, HVAC installers, and fabricators are the primary users of this tool.

This nibbler is suited for residential and light commercial HVAC ductwork fabrication, roofing panel work, and steel stud framing applications. It cuts aluminum, mild steel, and stainless steel without distorting the workpiece edge, making it a practical choice for straight cuts, curves, and radius cuts in sheet metal. The built-in thickness gauge helps operators verify material gauge before cutting. The chip disposal design directs cutoff slugs below the cutting surface, keeping the cut line clear and reducing debris on the work surface.

Key Features

• Cuts mild steel up to 10 gauge and stainless steel up to 13 gauge
• 6 amp motor at 1,300 SPM for consistent metal cutting performance
• Lock-on switch for reduced fatigue during extended operation
• Built-in thickness gauge for on-tool material verification
• Chip disposal directs slugs below the cutting material for a clear line of sight
• Hex wrench storage onboard for punch and die changes in the field
• Includes die, hex wrench, punch, and spanner wrench

Compatibility

Designed for cutting aluminum, mild steel, and stainless steel sheet material. Compatible with replacement punch part number 792728-1 and die part number 792292-2.

Installation Notes

Installation and operation should be performed by qualified sheet metal workers or HVAC technicians familiar with power nibbler tools. Disconnect the tool from power before changing the punch or die. Wear appropriate eye protection and gloves, as cut slugs are sharp-edged. Follow applicable OSHA hand tool safety guidelines and manufacturer torque guidance for punch and die fasteners.