Lynn Electronics MM9-LC Multimode Fiber 50um OM2 OM3 OM4

Product Description

The LYNN ELECTRONICS MM9-LC is a multimode fiber optic cable designed for structured cabling and data network installations. Built around a 50-micron core diameter, this cable meets OM2, OM3, and OM4 classification standards, making it compatible with a broad range of high-bandwidth transmission applications. The 900-micron tight-buffer construction provides added mechanical protection around the fiber strand, which is the standard format for indoor fiber patch and pigtail work. Licensed low-voltage technicians and network cabling contractors are the typical installers for this type of fiber.

This cable is suited for indoor fiber runs in commercial and light industrial environments where multimode transmission is required. The 50-micron core supports higher bandwidth performance compared to legacy 62.5-micron multimode fiber, making it appropriate for Gigabit Ethernet, 10GbE, and similar high-speed data applications over short to moderate distances. It is commonly used in telecommunications rooms, data centers, and structured cabling systems where OM2, OM3, or OM4 compliance is specified.

Key Features

• 50-micron core diameter supports OM2, OM3, and OM4 performance classifications
• 900-micron loose tube buffer construction provides mechanical protection for the fiber strand
• Multimode design supports short to moderate indoor transmission distances
• Compatible with standard LC and other common fiber connector terminations used in structured cabling
• Sold individually as a single unit

Compatibility

Designed as a standard 50-micron multimode fiber cable for use in OM2, OM3, and OM4 compliant structured cabling systems and network installations.

Installation Notes

Installation should be performed by a licensed low-voltage or fiber optic cabling technician following applicable building and fire codes for indoor cable routing. De-energize active network equipment before terminating or splicing fiber to avoid damage to transceivers. Observe minimum bend radius requirements specific to the cable to prevent signal loss or fiber damage. Fiber end faces should be properly cleaved and polished or terminated with pre-polished connectors per the manufacturer's procedure.