Lutron Electronics PJ2-4B-GWH-L01 4-button Pico Control

Product Description

The LUTRON ELECTRONICS PJ2-4B-GWH-L01 is a 4-button Pico wireless control designed for use with compatible Lutron lighting and load control systems. This compact, battery-powered remote gives occupants local or remote control of lights and other connected loads without requiring a dedicated wiring run to the mounting location. The white finish suits standard residential and light-commercial interiors. Electricians and low-voltage control technicians install this device as a supplemental or primary control point in Lutron radio-frequency systems.

The PJ2-4B-GWH-L01 is well suited to residential and light-commercial applications where a hard-wired switch location is impractical or where multi-point control is needed. Typical scenarios include adding a control point at a bed, sofa, or conference table, or providing a portable remote for a single-zone or multi-zone lighting layout. The four-button layout supports on, off, raise, and lower functions or scene assignments depending on system configuration.

Key Features

• Four-button layout supports on, off, raise, and lower commands or programmable scene control
• Wireless RF operation eliminates the need for a dedicated wiring run to the control location
• White finish blends with standard residential and commercial wall plates and trim
• Battery-powered design allows flexible placement anywhere within RF range of the system
• Compact form factor suitable for wall mounting, tabletop cradles, or handheld use

Compatibility

Designed for use with compatible Lutron radio-frequency lighting control systems that accept Pico wireless controls. Refer to the Lutron system compatibility guide and the product data sheet to confirm fit with a specific system before installation.

Installation Notes

Low-voltage wireless controls of this type are typically installed by licensed electricians or low-voltage systems technicians familiar with Lutron programming procedures. No line-voltage wiring is required for the Pico control itself, but the associated load controller or dimmer must be powered down at the breaker before any wiring work on that device. After physical placement, the control must be paired to the system receiver or main repeater per the manufacturer programming instructions before it will operate loads.