Lincoln Electric ED016363 Mig Welding Wire 0.045 in 10 Lb

Product Description

The LINCOLN ELECTRIC ED016363 is a flux-cored MIG welding wire rated to AWS specification E71T-11, designed for gasless, self-shielded wire-feed welding applications. At 0.045 inches in diameter and supplied on a 10-pound spool, this wire is suited for single-pass and limited-pass welding on mild steel in out-of-position work. The E71T-11 classification indicates an all-position flux-cored wire that operates without an external shielding gas, making it practical for field work, repair welding, and fabrication where gas cylinders are not available or practical. Licensed welders and fabricators handling structural or maintenance welding will find this wire compatible with standard wire-feed MIG equipment configured for flux-cored operation.

This wire is used in light structural fabrication, general-purpose repair, and maintenance welding on mild and low-carbon steel. The self-shielded, gasless design makes it well suited for outdoor environments where wind would compromise external shielding gas coverage. Typical installation scenarios include farm equipment repair, sheet metal fabrication, and general shop or field maintenance welding. It is appropriate for both shop and jobsite use where portability and minimal equipment setup are priorities.

Key Features

• AWS classification E71T-11 and E71T11-AZ-CS3 for recognized industry compliance
• Self-shielded flux-cored wire — no external shielding gas required
• All-position welding capability for out-of-position joints
• 0.045-inch wire diameter suitable for moderate-thickness mild steel
• 10-pound spool reduces changeover frequency in production or repair settings
• Compatible with standard wire-feed MIG welders configured for flux-cored wire

Compatibility

Designed as a self-shielded flux-cored replacement wire for standard MIG wire-feed welding equipment capable of running 0.045-inch flux-cored wire without external shielding gas.

Installation Notes

Installation and changeover should be performed by a qualified welder or welding technician. Power down the welding unit and disconnect it from the power source before loading a new spool. Verify that the drive rolls, liner, and contact tip are sized for 0.045-inch flux-cored wire before feeding. Follow applicable AWS and workplace safety standards for fume ventilation, as flux-cored welding produces slag and fume that require adequate exhaust or respiratory protection.