Lifesafety Power FPO75-C4D8E2M Access Power Supply

Product Description

The LIFESAFETY POWER FPO75-C4D8E2M is a 75-watt access control power supply designed to deliver regulated 12 or 24 volt DC output for electronic access control and security systems. It provides four dedicated lock outputs and eight auxiliary outputs, making it a multi-output distribution unit suited for mid-size access control installations. The E2M designation indicates an enclosure and management configuration appropriate for organized, monitored power distribution. Licensed security and low-voltage electricians install this unit as a centralized power source for electric strikes, magnetic locks, request-to-exit devices, and auxiliary field devices on the same system.

This power supply is used in commercial and light-industrial access control installations where multiple locking devices and auxiliary loads must be powered from a single, regulated DC source. It is well suited for door-control panels, multi-reader systems, and security head-end rooms where clean, stable power distribution across four lock circuits and eight auxiliary circuits is required. The selectable 12 or 24 volt DC output allows the installer to match the supply voltage to the connected hardware without additional conversion equipment.

Key Features

• 75-watt total output capacity supports multiple simultaneous lock and auxiliary loads
• Selectable 12 or 24 volt DC output voltage to match field device requirements
• Four dedicated lock outputs for electric strikes, magnetic locks, or similar hardware
• Eight auxiliary outputs for readers, REX devices, sensors, or other low-voltage accessories
• E2M enclosure and management configuration for organized, serviceable installation

Compatibility

Designed as an OEM-style replacement or new-installation power supply for commercial access control systems requiring regulated 12 or 24 volt DC multi-output distribution.

Installation Notes

This unit is installed by licensed low-voltage technicians or electricians in accordance with NEC Article 725 governing Class 2 and Class 3 remote-control and signaling circuits. De-energize all connected access control hardware and discharge any battery backup before servicing or wiring the unit. Verify that the total connected load across all lock and auxiliary outputs does not exceed the 75-watt supply rating before commissioning. Follow the manufacturer wiring diagram for output circuit assignments to avoid overloading individual output channels.