Lifesafety Power FPO150-B100D8E2M Access Power Supply

Product Description

The LIFESAFETY POWER FPO150-B100D8E2M is an enclosed access control power supply rated at 150 watts with selectable 12-volt and 24-volt output. It provides eight auxiliary outputs, making it well suited for powering multiple access control devices from a single centralized source. The unit ships in an enclosure, allowing for cleaner panel installations where exposed board mounting is not practical. Security integrators and low-voltage electricians install this class of power supply in commercial and light-commercial access control systems to deliver reliable, regulated DC power to door controllers, electric locks, and similar field devices.

This power supply is intended for use in access control installations where multiple powered outputs are required within a single cabinet. The enclosed form factor suits rack-room or utility-closet deployments where the power distribution hardware must be housed neatly. The 12-volt and 24-volt dual-voltage capability accommodates a range of downstream devices without requiring separate supplies for each voltage level. Installations governed by NFPA 70 (NEC) low-voltage provisions and local access control codes will find this unit appropriate for those environments.

Key Features

• 150-watt total output capacity for powering multiple access control loads
• Selectable 12-volt and 24-volt DC output to match downstream device requirements
• Eight auxiliary outputs for distributing power across multiple field devices
• Enclosed housing provides physical protection and supports clean cabinet installations
• Single-unit solution reduces wiring complexity in multi-device access control panels

Compatibility

Designed as an OEM-style replacement or direct-install access power supply for enclosed access control power distribution applications requiring 150-watt capacity with dual-voltage and multiple auxiliary outputs.

Installation Notes

Installation should be performed by a licensed low-voltage electrician or qualified security systems integrator in accordance with NFPA 70 (NEC) Article 725 and applicable local codes. Disconnect all power to the panel and verify zero voltage before making any wiring connections. Do not exceed the rated output load across the auxiliary circuits. Verify output voltage selection matches the requirements of all connected devices before energizing the unit.