Leviton Telcom L8712-100 Pull Grip De-lace

Product Description

The LEVITON TELCOM L8712-100 is a de-lace pull grip designed for securing and pulling cable bundles in the 0.5 to 0.75 inch diameter range. Pull grips of this type use a woven mesh sleeve that tightens around the cable bundle under tension, allowing technicians to pull wire and cable through conduit, trays, and raceways without damaging the jacket or insulation. This hardware accessory is a single-unit item sold individually and is a standard tool in low-voltage and structured cabling installations.

This pull grip is suited for telecommunications, data cabling, and low-voltage wiring work in both commercial and residential settings. It is typically used during the rough-in or finish phase of structured wiring installations where cable bundles must be routed through walls, conduit, or cable management systems. The de-lace design allows for clean attachment to pre-bundled cable runs without the need for additional lacing or tape.

Key Features

• Compatible with cable bundle diameters from 0.5 to 0.75 inches
• De-lace design eliminates need for separate lacing material on the bundle
• Mesh sleeve tightens under pull tension for secure grip
• Sold as a single unit for job-specific use
• Classified as a hardware accessory for structured cabling and telecom applications

Compatibility

Designed as a standard pull grip hardware accessory for cable bundles with an outside diameter between 0.5 and 0.75 inches, typical in low-voltage and telecommunications cabling installations.

Installation Notes

Installation is performed by licensed low-voltage technicians or electricians familiar with cable pulling practices. Before pulling, verify that conduit or raceway is clear and that the cable bundle diameter falls within the 0.5 to 0.75 inch range specified for this grip. Do not exceed the rated pull load for the grip or the minimum bend radius of the cables being pulled. Follow applicable codes including NFPA 70 (NEC) for low-voltage wiring installations.