Leviton Telcom L8557-100 Pull Grip 2.5-3 in Double Weave

Product Description

The LEVITON TELCOM L8557-100 is a single-entry pull grip designed for cable pulling applications where a secure, low-profile termination is required. This hardware accessory uses a double-weave mesh construction to grip cables with diameters in the 2.5 to 3 inch range. The short-body design suits confined pathways and tight conduit entries. Electricians and low-voltage technicians reach for pull grips like this when pulling heavy cable through conduit, cable trays, or open raceways where a reliable mechanical hold must be maintained throughout the pull without damaging the cable jacket.

This pull grip is suited for use on bundled conductors, large-diameter communication cables, or single large power conductors that fall in the 2.5 to 3 inch outer diameter range. The single-entry configuration accepts one cable end. It is a standard tool-side accessory used during rough-in and final pull stages on commercial and industrial wiring projects. Installation crews on data centers, industrial facilities, and large commercial buildouts commonly stock this type of grip for planned and emergency cable pulls.

Key Features

• Double-weave mesh construction distributes pull load evenly across the cable jacket
• Fits cable outer diameters from 2.5 to 3 inches
• Single-entry design for individual cable termination at the pull point
• Short-body form factor suits confined spaces and tight conduit entries
• Sold as an individual unit (each)

Compatibility

Designed as an OEM-style hardware accessory for use with cables in the 2.5 to 3 inch outer diameter range in standard cable pulling applications.

Installation Notes

Pull grips are installed by licensed electricians or low-voltage cable technicians following applicable NEC guidelines for cable pulling. De-energize all circuits in the pull path before beginning work. Inspect the weave for any deformation before attaching to the cable, and confirm the cable diameter falls within the rated range before applying pull tension. Do not exceed the rated load capacity of the grip or the minimum bend radius of the cable being pulled.