Leviton Telcom 6L307-CFG Fiber Optic Mmu 7M 3P4W

Product Description

The LEVITON TELCOM 6L307-CFG is a multimode fiber optic management unit (MMU) in a large form factor, supplied as a pre-terminated assembly measuring 7 meters in length with a 3-pole, 4-wire (3P4W) configuration. This unit is designed for structured cabling installations where multimode fiber runs require organized, factory-terminated connectivity between distribution points and active equipment. It is typically installed by low-voltage cabling technicians and network infrastructure specialists working in commercial or data center environments where reliable fiber routing and management are critical.

This assembly is suited for horizontal or backbone fiber distribution in commercial buildings, server rooms, and telecommunications closets. The 7-meter length and 3P4W configuration make it applicable to patch panel consolidation points, equipment rack-to-rack runs, and zone cabling layouts where pre-terminated assemblies reduce field termination time and minimize insertion loss variability. No specific compatible model numbers or system families are identified in the available product data.

Key Features

• Factory pre-terminated multimode fiber assembly reduces field termination time
• 7-meter length supports short- to mid-range intra-rack and inter-rack runs
• 3P4W configuration provides multi-fiber connectivity in a single managed assembly
• Large MMU form factor accommodates higher fiber counts and structured routing
• Sold as a single unit (EA), simplifying procurement for exact-count installations

Compatibility

Designed as an OEM-style fiber optic management assembly for use in multimode structured cabling systems; no specific compatible model numbers or system families were identified in the available product data.

Installation Notes

Installation should be performed by a qualified low-voltage cabling technician familiar with TIA-568 and ISO 11801 structured cabling standards. Power down or de-activate any active optical transceivers connected to this run before handling fiber connectors to avoid eye hazard from laser light sources. Avoid sharp bend radii below the minimum bend radius specified for the fiber type to prevent signal attenuation or physical damage. Secure the assembly using appropriate cable management hardware to prevent stress on the factory-terminated connectors.