Lenox 93289RPB175335 Bandsaw Blade 210in Bi-metal 5-8 Tpi

Product Description

The LENOX 93289RPB175335 is a welded bi-metal bandsaw blade engineered for demanding metal-cutting applications. Measuring 210 inches in length and 1.5 inches in width, this blade features a variable-pitch tooth form at 5 to 8 TPI, reducing harmonic vibration and chatter during cuts. The M42 high-speed steel tooth material delivers heat and wear resistance for extended blade life. A spring steel back provides flex strength and fatigue resistance under continuous band tension. Licensed HVAC and mechanical contractors, pipefitters, and metal fabricators regularly use blades of this type on horizontal and vertical bandsaws.

This blade is suited for production cutting of structural metals, pipe, tubing, and solid stock on industrial and commercial bandsaw units. The variable Vari-Raker tooth set promotes efficient chip evacuation and consistent kerf quality across a range of material cross-sections. The 0.08-inch kerf width is appropriate for ferrous and non-ferrous metals. No contour cutting is intended with this blade. Operators working in fabrication shops, mechanical rooms, and trade service environments will find this blade fits standard vertical and horizontal bandsaws accepting 210-inch loop lengths.

Key Features

• M42 high-speed steel teeth for heat resistance and extended cutting life
• Variable 5 to 8 TPI pitch reduces vibration and improves surface finish
• Vari-Raker tooth set for efficient chip clearance on ferrous and non-ferrous stock
• Spring steel back construction resists fatigue under continuous band tension
• 0.08-inch kerf width for consistent, repeatable cuts
• Welded loop construction eliminates mechanical joint failure points

Compatibility

Designed as a replacement or stock blade for bandsaws accepting a 210-inch welded loop, 1.5 inches wide, with standard blade tensioning systems. Verify your machine's blade length specification before installation.

Installation Notes

Blade installation should be performed by a qualified operator familiar with bandsaw tension and tracking procedures. Disconnect and lock out the bandsaw from its power source before removing or installing any blade. Confirm wheel guards and blade guides are properly reset and adjusted after installation. Do not exceed the blade speed or feed rate specified by the bandsaw manufacturer for the material being cut.