Lenox 4029NEC3895 Band Saw Blade Coil 10 Tpi 3/8 in 100 Ft

Product Description

The LENOX 4029NEC3895 is a carbon steel band saw blade coil stock designed for continuous cutting applications where shop-cut blade lengths are required. The coil measures 100 feet and yields multiple custom-length blades to fit a range of band saw frames. At 3/8 inch wide and 0.025 inch thick, this blade is sized for general-purpose contour and straight cutting. The hard back construction resists flex fatigue during extended cuts, and the raker tooth set with a constant 10 teeth per inch pitch delivers consistent chip removal in wood, non-ferrous metal, and plastic stock. Fabricators and maintenance technicians cut lengths to spec and weld or braze ends on-site.

This coil stock is suited for production shops, maintenance facilities, and service operations that run multiple band saws and prefer to stock bulk blade material rather than pre-cut blades. The 3/8 inch width handles contour cuts with moderate radius curves while remaining stiff enough for ripping straight lines. The constant 10 TPI pitch is well matched to medium-density materials and uniform cross-sections where a consistent feed rate is maintained throughout the cut.

Key Features

• Carbon steel construction provides good wear resistance for general-purpose cutting applications
• Hard back design reduces blade fatigue and maintains straightness under continuous load
• Raker tooth set clears chips efficiently from the kerf during each stroke
• Constant 10 TPI pitch delivers predictable, smooth cuts in uniform material cross-sections
• Straight tooth form suits ripping and crosscutting in wood, plastics, and soft non-ferrous stock
• 100-foot coil length supports shop-cut custom sizing for multiple saw frames

Compatibility

Designed as bulk coil stock for band saws that accept 3/8 inch wide blades; end users cut and join to the required loop length for their specific saw frame.

Installation Notes

Cutting and welding band saw blade coil stock should be performed by a qualified technician using a blade welder and appropriate personal protective equipment including cut-resistant gloves and eye protection. Verify the finished blade tension, tracking, and guard settings before operating the saw, following the saw manufacturer guidelines and applicable ANSI safety standards. Never operate a band saw with a blade that has visible cracks, missing teeth, or improper weld joints.