Lenox 1348D2C1464 Band Saw Blade Coil 6 Tpi 1/4 in 100 Ft

Product Description

The LENOX 1348D2C1464 is a bi-metal band saw blade coil stock designed for continuous-length cutting applications in metal fabrication, plumbing, HVAC, and general trade work. The coil measures 100 feet in length and 1/4 inch wide with a 0.035 inch blade thickness, giving technicians and fabricators the flexibility to cut blades to the exact length needed for any band saw frame. The blade runs a constant 6 teeth per inch (TPI) hook-tooth pattern, making it well suited for moderate-thickness metal stock. High speed steel teeth are electron-beam welded to a flexible alloy steel back, combining edge hardness with resistance to blade fatigue and breakage during contour cuts.

This coil stock is intended for use in metal-cutting band saws in both residential service and commercial fabrication environments. Typical applications include cutting copper pipe, conduit, steel tubing, angle iron, and structural shapes. The flexible back construction makes it especially practical for contour cutting on curved or irregular workpieces. HVAC technicians, plumbers, electricians, and general fabricators who run band saws regularly will benefit from keeping a full 100-foot coil on hand to weld or pin custom blade lengths as needed rather than stocking multiple pre-cut blades.

Key Features

• Bi-metal construction: high speed steel teeth bonded to a flexible alloy steel back for durability and fatigue resistance
• 6 TPI constant-pitch hook-tooth pattern optimized for moderate-thickness metal cutting
• 1/4 inch blade width and 0.035 inch thickness for compatibility with narrow-throat band saw guides
• 100-foot coil allows custom blade lengths to be cut and welded on-site
• Flexible back design supports contour cutting on curved or irregular workpieces
• Lenox tooth set geometry for consistent kerf width and reduced blade drift

Compatibility

Designed as a continuous coil replacement for use in metal-cutting band saws that accept 1/4 inch wide bi-metal blade stock. Confirm your band saw's guide and wheel specifications before cutting and welding blades from this coil.

Installation Notes

Cutting and welding band saw blades from coil stock is typically performed by experienced fabricators or tool-shop technicians using a blade welder and blade grinder. Always power down and disconnect the band saw from its power source before installing or changing blades. Wear cut-resistant gloves when handling coil stock, as the blade edges remain sharp throughout handling. Follow the band saw manufacturer's tensioning and tracking procedures when mounting a newly welded blade.