Lenox 1128MAC12127 Band Saw Blade Coil 14 Tpi 1/2 in

Product Description

The LENOX 1128MAC12127 is a bi-metal band saw blade coil stock designed for continuous-use cutting applications in metal fabrication and industrial trades. The coil measures 250 feet in length and 1/2 inch in width, with a blade thickness of 0.02 inches, providing a generous supply for high-volume blade production or custom-length cutting. The tooth material is high speed steel set in a wavy pattern at 14 teeth per inch (TPI) with a constant pitch, delivering consistent, burr-controlled cuts through a wide range of materials. The flexible back construction allows the blade to run smoothly on standard band saw wheels without fatigue cracking over extended service cycles.

This coil stock is well suited for metal fabrication shops, HVAC sheet metal operations, plumbing supply houses, and industrial maintenance environments where band saw blades are consumed in volume. The 14 TPI wavy-set configuration is a proven general-purpose geometry for cutting thin-wall tubing, structural shapes, and light bar stock. Installers and shop technicians cut the coil to required lengths and weld ends together using a butt welder to produce finished band saw blades sized to their specific machines.

Key Features

• Bi-metal construction with high speed steel teeth for extended cutting life
• 14 TPI constant pitch with wavy tooth set for smooth, controlled cuts in thin and medium-section materials
• 1/2 inch blade width at 0.02 inches thickness suits a broad range of band saw wheel sizes
• 250-foot coil length provides ample stock for multiple blade fabrications before reordering
• Flexible back design resists fatigue cracking during continuous high-cycle operation
• Straight tooth form with toothed cutting edge for consistent chip evacuation

Compatibility

Designed as coil stock for fabrication into finished band saw blades sized to fit machines that accept 1/2 inch wide blades; verify wheel diameter, blade length, and welder capacity before cutting.

Installation Notes

Blade fabrication from coil stock should be performed by qualified shop technicians using a band saw blade butt welder and blade grinder. Wear cut-resistant gloves and eye protection when handling and uncoiling band saw blade stock, as the material is under tension and edges are sharp. After welding, inspect the weld joint for proper alignment and grind flush before installing on the saw. Follow the band saw manufacturer guidelines for blade tension and wheel tracking before resuming cuts.