Lenox 1126D2C3895 Band Saw Blade Coil 3/8 in 250 Ft

Product Description

The LENOX 1126D2C3895 is a bi-metal band saw blade coil stock designed for continuous cutting operations where field-cut blade lengths are required. The coil measures 250 feet in total length, with a blade width of 3/8 inches and a blade thickness of 0.035 inches. The cutting edge features high speed steel teeth set in a straight tooth form at a constant 10 teeth per inch pitch, making it well suited for consistent, repeatable cuts in metal and other materials. The flexible back construction allows the blade to be cut and welded to length on-site or at a service shop, reducing downtime and blade inventory overhead. This coil is a practical stocking solution for shops running high blade volume.

This coil stock is intended for use in band saw applications where contour cutting capability is needed. The constant 10 TPI pitch and toothed cutting edge perform reliably in ferrous and non-ferrous metal cutting scenarios common in mechanical, HVAC, plumbing, and general trade fabrication work. The Lenox tooth set geometry supports controlled chip clearance during cuts. Shops, service trucks, and trade contractors that frequently cut pipe, conduit, angle iron, or structural stock will find the 250-foot coil format reduces the need for frequent blade replenishment.

Key Features

• Bi-metal construction with high speed steel teeth for extended blade life in metal cutting
• Constant 10 TPI pitch for consistent chip load and smooth cut finish
• Flexible back design supports coil storage and field welding to custom lengths
• Straight tooth form with Lenox tooth set for controlled cutting geometry
• Contour cutting capable for curved or profile cuts
• 250-foot coil format reduces per-job blade sourcing and stocking complexity

Compatibility

Designed as a coil stock replacement for band saws accepting 3/8 inch wide bi-metal blades. Blade must be cut and welded to the required loop length to match the specific band saw being serviced.

Installation Notes

Blade cutting and welding should be performed by a qualified technician using a band saw welder and blade grinder. Ensure the band saw is fully powered down and unplugged before removing or installing any blade. Verify the finished blade length, width, and thickness match the band saw manufacturer specifications before tensioning. Wear cut-resistant gloves when handling coil stock, as unsupported coil can spring and cause injury.