Lenox 1017D2C12127 Band Saw Blade Coil 10 Tpi Bi-metal

Product Description

The LENOX 1017D2C12127 is a bi-metal band saw blade coil stock designed for continuous-cut applications in metal fabrication and general trade work. The coil measures 100 feet in length and 0.5 inches wide with a blade thickness of 0.035 inches, giving technicians and fabricators a bulk supply to cut custom blade lengths as needed. The cutting edge uses high speed steel teeth in a constant-pitch, raker-set configuration at 10 teeth per inch, which balances cut speed with surface finish on a broad range of materials. The flexible back reduces blade stress during contour cuts and coiling, extending service life in demanding shop environments.

This coil stock is suited for metal-cutting band saws in commercial fab shops, HVAC sheet metal fabrication, plumbing and mechanical contractor shops, and general trade applications where blade length requirements vary by job. The 10 TPI constant pitch is effective on solid steel bar stock, structural profiles, and tubing wall thicknesses common in trade work. Purchasing in coil form allows shops to weld or pin custom lengths to fit a range of band saw models rather than stocking multiple pre-welded blades.

Key Features

• Bi-metal construction with high speed steel teeth for extended cutting life on metal stock
• 10 TPI constant pitch for consistent chip load across solid and hollow sections
• Raker tooth set for efficient chip clearance and reduced heat buildup
• Flexible back design supports contour cutting and minimizes fatigue cracking during coiling
• 100-foot coil allows custom blade lengths to be cut and welded to shop specification
• 0.035-inch blade thickness compatible with standard band saw wheel tolerances

Compatibility

Designed as bulk coil stock for band saws that accept 0.5-inch-wide bi-metal blades; individual lengths are cut and welded or pinned to fit specific saw models per shop practice.

Installation Notes

Blade welding and tensioning should be performed by a qualified shop technician using a blade welder rated for bi-metal stock. Power down and lock out the band saw before installing or changing blades. Verify wheel diameter, blade width capacity, and tension range on the saw before cutting a length from the coil. Wear cut-resistant gloves when handling uncoiled blade stock, as the toothed edge presents a laceration hazard.