Legris 3193 12 17 Male Run Tee Fitting 290 Psi Bspp

Product Description

The LEGRIS 3193 12 17 is a push-to-connect male run tee tube fitting designed for pneumatic and fluid control plumbing systems. It accepts tubing with a 12 mm outside diameter and provides a 3/8 inch BSPP male thread branch connection, allowing a straight run of tubing to be teed off to a threaded port without additional tools at the tube end. The body is constructed of glass-reinforced nylon with nickel-plated brass internal components. Rated to 290 psi maximum working pressure, it handles operating temperatures from -4 degrees F to 175 degrees F and carries a vacuum rating of 28 in-Hg. Installed by plumbers, pneumatic system technicians, and industrial maintenance trades.

This fitting is suited for compressed air lines, pneumatic control circuits, and fluid distribution plumbing in both light industrial and commercial settings. The push-to-connect design allows fast, tool-free tube insertion on the run side, while the BSPP male thread end connects directly to manifolds, valves, or ported equipment. The nitrile O-ring sealing material makes it compatible with air, water, and a range of non-aggressive fluids. Typical install scenarios include instrument air distribution panels, process control cabinetry, and light-duty hydraulic or pneumatic manifold assemblies operating within the rated pressure and temperature envelope.

Key Features

• Push-to-connect tube ends accept 12 mm OD tubing without additional tools
• 3/8 inch BSPP male thread for direct port connection to valves or manifolds
• 290 psi maximum working pressure rating
• Operating temperature range of -4 degrees F to 175 degrees F
• 28 in-Hg vacuum rating supports both pressure and vacuum circuit use
• Glass-reinforced nylon body with nickel-plated brass internals and nitrile O-ring seals

Compatibility

Designed as an OEM-style push-to-connect replacement fitting for pneumatic and fluid systems using 12 mm OD tubing and 3/8 inch BSPP threaded ports.

Installation Notes

Installation should be performed by a qualified technician familiar with pneumatic or fluid piping systems. De-pressurize and isolate the circuit completely before removing or installing any push-to-connect fitting. Ensure the tube end is cut squarely, deburred, and clean before insertion to achieve a proper seal. Verify that the connected tubing OD and system pressure and temperature do not exceed the rated values for this fitting.