Legris 3193 10 13 Male Run Tee Push-to-connect 290 Psi

Product Description

The LEGRIS 3193 10 13 is a push-to-connect male run tee tube fitting designed for pneumatic and fluid distribution systems requiring a reliable inline branch connection. The body is constructed from glass-reinforced nylon with nickel-plated brass internal components and a nitrile O-ring seal, making it suitable for use in compressed air, water, and compatible fluid lines. It handles a maximum working pressure of 290 psi and operates across a temperature range of -4 degrees F to 175 degrees F. The push-to-connect design allows fast, tool-free tube insertion, reducing assembly time in panel builds, manifolds, and plumbing runs. Licensed plumbers, pipefitters, and pneumatic system technicians are the typical installers.

This fitting is used in residential and light commercial pneumatic systems, compressed air distribution networks, and fluid control assemblies. The male run tee configuration allows a branch takeoff while maintaining straight-through flow along the main run. The 1/4 inch BSPP (British Standard Parallel Pipe) male thread connects to standard BSPP-tapped ports and manifolds. The 10 mm tube outside diameter ports accept metric push-to-connect tubing. This fitting is well suited for control panel plumbing, automation equipment, and general compressed air service lines where a compact inline tee is needed.

Key Features

• Push-to-connect design for fast, tool-free tube insertion and removal
• 290 psi maximum working pressure for standard compressed air service
• Glass-reinforced nylon body with nickel-plated brass internals for corrosion resistance
• Nitrile O-ring seal compatible with air, water, and many common fluids
• 1/4 inch BSPP male thread for connection to metric-standard ported equipment
• Rated for vacuum service up to 28 in-Hg

Compatibility

Designed as an OEM-style push-to-connect replacement fitting for pneumatic and fluid distribution systems using 10 mm outside diameter tubing and 1/4 inch BSPP male thread ports.

Installation Notes

Depressurize and isolate the system completely before removing or installing any push-to-connect fitting. Verify that the tubing outside diameter matches the 10 mm port specification and that the mating port is threaded to BSPP standards before installation. BSPP is a parallel thread form and requires an O-ring or sealing washer face seal rather than PTFE tape for a pressure-tight connection. Inspect tube ends for clean, square cuts and remove any burrs before insertion to ensure proper collet engagement and a leak-free seal.