Legris 0124 06 00 Compression Tube Sleeve Brass 6mm

Product Description

The LEGRIS 0124 06 00 is a brass compression tube sleeve designed to join two compression-style tube ends in pneumatic and fluid distribution systems. The sleeve accepts tubing with a 6 mm outside diameter and is rated to a maximum working pressure of 460 psi, making it suitable for moderate-pressure service lines. Its operating temperature range spans -40 degrees F to 210 degrees F, supporting use in both cold ambient environments and heated process lines. Licensed plumbers, HVAC technicians, and industrial piping contractors install this fitting type during panel assembly, distribution manifold work, and inline tube repair tasks.

This sleeve is a straight union-style fitting intended for compression-to-compression connections on 6 mm OD tubing. It is suited for residential and light commercial fluid or pneumatic circuits where a clean, leak-resistant tube-to-tube joint is required without additional adapters. The all-brass construction resists corrosion in water, air, and compatible hydraulic media. Compliance with ATEX, PED, Prop 65, REACH, RoHS, and WEEE standards makes this fitting appropriate for projects requiring documented material and safety certifications.

Key Features

• Brass body construction provides corrosion resistance across a broad range of compatible fluid and pneumatic media
• Rated to 460 psi maximum working pressure for reliable service in moderate-pressure lines
• Wide temperature range of -40 degrees F to 210 degrees F supports diverse installation environments
• Compression x compression end connections for tool-optional, sleeve-and-nut assembly on 6 mm OD tubing
• Certified to ATEX, PED, Prop 65, REACH, RoHS, and WEEE standards for regulated-project compliance

Compatibility

Designed as an OEM-style compression sleeve for 6 mm outside diameter tubing in pneumatic and fluid distribution systems requiring compression x compression end connections.

Installation Notes

Installation is typically performed by licensed plumbers or HVAC technicians following applicable IPC or system-manufacturer guidelines. Depressurize and drain or bleed the line fully before disassembling any existing fitting. Ensure tubing ends are cut square and deburred before seating them in the compression sleeve to achieve a proper seal. Do not overtighten the compression nuts; follow the fitting manufacturer's assembly instructions for correct engagement.