Larsen Supply Co. 10-1372 Water Heater Flex Connector 15 in

Product Description

The LARSEN SUPPLY CO., INC. 10-1372 is a 304 stainless steel flexible water heater connector designed to link water heater inlets and outlets to residential supply lines. Measuring 3/4 inch x 3/4 inch x 15 inches, it features chrome-plated brass nuts and a no-kink construction that accommodates a range of installation angles without compromising flow or structural integrity. The 304 stainless steel braid resists corrosion in both potable water and light commercial service environments. Plumbers and water heater installers rely on this connector for straightforward hot and cold supply hookups during new installations and equipment replacements.

This flex connector is suited for residential water heater installations where a 3/4-inch connection size is required on both the supply and appliance ends. The 15-inch length provides enough flexibility to align with supply stubs in typical utility closet, basement, and garage installations. The no-kink design is particularly useful in tight spaces where a straight run is not possible. Each connector is individually hang-tagged, making it practical for retail or shop stocking as well as direct job-site use. Package quantity is 6 units per case.

Key Features

• 304 stainless steel construction for corrosion resistance in potable water applications
• No-kink design allows flexible routing in confined installation spaces
• Chrome-plated brass nuts provide a secure, leak-resistant connection
• 3/4 inch x 3/4 inch end fittings match standard residential water heater port sizing
• 15-inch length suits typical supply-stub-to-appliance distances
• Individual hang tag included for easy identification and stocking

Compatibility

Designed as an OEM-style replacement or new-installation connector for residential water heaters requiring 3/4-inch inlet and outlet supply connections.

Installation Notes

Installation is performed by licensed plumbers or qualified water heater technicians. Shut off the cold water supply and power or gas to the water heater before disconnecting any existing connectors. Hand-tighten the brass nuts first, then snug with a wrench — avoid over-tightening, which can crack the fitting seat. Inspect both mating ports for debris or old thread tape before making the new connection, and follow all applicable local plumbing codes.