L H Dottie Co WTHGL125 Weathertight Hub 1-1/4 Inch

Product Description

The L H Dottie Co WTHGL125 is a 1-1/4 inch weathertight hub with an integrated gasket, designed to provide a sealed conduit entry point at electrical enclosures, panels, and junction boxes. The gasket compresses against the enclosure wall to create a moisture-resistant seal, preventing water intrusion at the conduit connection. This type of fitting is a standard component in exterior and wet-location electrical installations where standard locknuts alone would not provide adequate environmental protection. Electricians and electrical contractors install this fitting when terminating conduit runs into enclosures exposed to rain, humidity, or wash-down conditions.

The WTHGL125 fits 1-1/4 inch conduit and is suited for use in residential, commercial, and light industrial applications wherever a weathertight conduit termination is required. Typical installation scenarios include service entrance equipment, outdoor disconnect boxes, exterior panel enclosures, and any conduit stub-up or stub-out entering a NEMA-rated enclosure exposed to outdoor or wet environments. The built-in gasket eliminates the need for a separate sealing washer at installation.

Key Features

• Integrated gasket provides a moisture-resistant seal at conduit-to-enclosure entry points
• Sized for 1-1/4 inch conduit trade size
• Eliminates the need for a separate sealing washer during installation
• Suitable for wet and damp location conduit terminations
• Sold individually — one fitting per unit

Compatibility

Designed as an OEM-style weathertight conduit hub fitting for use with 1-1/4 inch trade size conduit terminating into standard knockouts on electrical enclosures, panels, and junction boxes rated for wet or damp locations.

Installation Notes

Installation is performed by licensed electricians in accordance with applicable NEC requirements for wet and damp location conduit fittings. De-energize all circuits and lock out the panel or enclosure before beginning work. Thread the hub into the knockout opening and tighten to compress the gasket evenly against the enclosure wall for a proper seal. Do not overtighten, as this can damage the gasket and compromise the weathertight seal.