L H Dottie Co TEKPH634 Phillips Pan Head Screw 100-pack

Product Description

The L H Dottie Co TEKPH634 is a 100-pack of No. 6 x 0.75 inch Phillips pan head screws suited for light-duty fastening tasks in mechanical, electrical, and general trade work. These tek-style self-drilling fasteners drive with a standard Phillips No. 2 bit, eliminating the need for a pilot hole in most light-gauge applications. The pack quantity of 100 makes them practical for service vans, job boxes, and panel-work where small-diameter fasteners are consumed in volume. Installers working across HVAC, electrical, and plumbing trades will find these screws a routine stock item.

These screws are suited for residential and light commercial applications where a No. 6 diameter fastener is specified. Common uses include securing junction box covers, light-gauge sheet metal trim, electrical enclosure panels, and access doors. The 0.75 inch length is appropriate for thin-material fastening where deeper penetration is not required or desired. Trades that regularly stock small Phillips fasteners will find the 100-count pack a convenient replenishment quantity for daily service work.

Key Features

• No. 6 diameter x 0.75 inch length for thin-material fastening
• Phillips drive for use with standard No. 2 Phillips bits and drivers
• Pan head profile distributes clamping load across the material surface
• 100-pack quantity supports high-volume fastening tasks and van stock replenishment
• Self-drilling tip design reduces the need for pre-drilling in light-gauge substrates

Compatibility

Designed as a general-purpose No. 6 x 0.75 inch Phillips pan head screw suitable for light-gauge sheet metal, electrical enclosures, and similar thin-material fastening applications common across HVAC, electrical, and plumbing trades.

Installation Notes

Install with a No. 2 Phillips bit using an electric screwdriver or drill driver set to a controlled torque clutch setting to avoid stripping the drive recess. De-energize any electrical enclosure or panel before fastening covers or components per NFPA 70 (NEC) requirements. Avoid over-driving, which can deform the pan head and reduce clamping effectiveness on thin materials.