L H Dottie Co SDS3610 Sds Plus Rotary Hammer Bit

Product Description

The L H DOTTIE CO SDS3610 is an SDS Plus rotary hammer drill bit designed for use in SDS Plus compatible rotary hammer tools. With a diameter of 3/16 inches and an overall length of 10 inches, this bit is built for drilling into concrete, masonry, and similar hard materials encountered on commercial and residential job sites. It is sold individually and suits electricians, plumbers, HVAC technicians, and general contractors who need precise anchor or conduit holes through structural substrates.

This bit is a standard fit for SDS Plus rotary hammers, making it a practical addition to any trade tool kit where penetrating concrete block, poured concrete, or brick is part of the daily workflow. The 3/16-inch diameter is commonly used for setting smaller concrete anchors, driving through mortar joints, or creating pilot points for larger hole saws in masonry applications.

Key Features

• SDS Plus shank for quick, tool-free bit changes on compatible rotary hammer tools
• 3/16-inch diameter suits smaller anchor and pilot hole applications in masonry
• 10-inch length provides extended reach for deep penetration through thick substrates
• Sold individually, allowing single-bit procurement to match job requirements

Compatibility

Designed as a direct-fit replacement or supplemental bit for rotary hammer tools with standard SDS Plus chuck interfaces.

Installation Notes

Installation is performed by qualified tradespeople using SDS Plus rotary hammer tools. Ensure the hammer is powered off and unplugged before inserting or removing the bit. Wear appropriate eye and hearing protection during use. Consult applicable local codes and anchor manufacturer specifications when drilling for structural fastener placements.