L H Dottie Co HPD200 Conduit Die 1-1/2 Inch

Product Description

The L H Dottie Co HPD200 is a replacement conduit die sized for 1-1/2 inch conduit bending applications. Conduit dies are used in conjunction with compatible conduit benders to form accurate, consistent bends in electrical conduit runs. This die fits into the bender shoe assembly and determines the bend radius for the conduit size it is matched to. It is a hardware accessory sold individually and is handled primarily by licensed electricians during conduit installation work.

This die is suited for electrical conduit work in both residential and commercial settings where 1-1/2 inch conduit runs require field bending. It is a direct replacement or spare die for bender setups that accept this size. Electricians working on panel feeds, branch circuit runs, or service entrance conduit will find this die applicable to standard EMT or rigid conduit bending tasks at the 1-1/2 inch size.

Key Features

• Sized for 1-1/2 inch conduit bending applications
• Sold individually as a single unit
• Designed as a replacement or spare die for compatible bender assemblies
• Hardware accessory category suitable for jobsite electrical work

Compatibility

Designed as a replacement conduit die for compatible 1-1/2 inch conduit bender assemblies. Consult the bender manufacturer documentation to confirm die fitment before installation.

Installation Notes

Conduit dies are installed and replaced by licensed electricians following applicable NEC guidelines for conduit bending and support. Ensure the bender is not under load and the conduit is properly secured before swapping or seating the die. Do not force the die into an incompatible bender shoe, as this can damage both the die and the bender assembly.